Stage 4 Turbo package is suitable for the Peugeot RCZ 200bhp with an EP6 1.6L 16v Turbo engine.

At Pug1Off, we’ve had a lot of experience with hybrid turbos that use the original castings. Although good gains can be achieved, the turbos can be expensive and still produce disappointing torque that falls away too steeply after 4000rpm, especially noticeable in high gears. This kit has been designed to give a wide spread of power, without too much lag, whilst retaining the factory turbine housing fitments to the manifold and downpipe

This kit includes:

Pug1Off / Turbo Technics Turbo:

All new K04-based bespoke performance turbocharger (no re-used parts)

Large, high-flowing billet aluminium compressor wheel
Full-size K04 turbine wheel for excellent power/response balance
TT designed an upgraded compressor housing
- Bespoke casting design with larger volute/scroll
- Larger internal aerodynamic design improves the efficiency of the large compressor wheel
- “Anti-surge” ports for a wider flow range
- Removes restrictive inlet design of OE turbocharger
TT designed bespoke turbine housing, incorporating:
- Increased volute/scroll size for higher maximum flow
- Pulse converter technology to help low-end response
- High-flowing internal wastegate design
K04-spec journal bearing system for increased durability/reliability
TT designed an uprated 360° thrust bearing assembly, to handle increased thrust loading from a higher boost
- CHRA finely balanced to high specification, on Turbo Technics VSR
- Turbine end based on standard turbocharger footprint for a drop-in/direct-fit upgrade with fitting kit
Capable of well over 300bhp!

Bespoke Silicone Intake pipe

Bespoke Boost pipe (turbo to intercooler) with billet dump valve mount

Genuine Peugeot downpipe gasket and turbo fire ring

Along with the parts above, there are also supporting modifications that are required:

Clutch Kit:

Due to the torque increase, your standard clutch will no longer be up to the job. We recommend the Helix organic clutch kit, this can either be run with your standard dual mass flywheel or you can take this opportunity to upgrade to a matching Helix Billet Steel Flywheel. Whether you select the clutch or the clutch and flywheel kit, you will be supplied with new diff seals and a clutch slave cylinder. With the flywheel, you also get a set of ARP flywheel bolts.

Conrod Bolts:

These ARP 2000 conrod bolts are a non-stretch high tensile material ideal for high power outputs and extended rev limits where forged rods are not essential. Ultimately providing insurance against stretching and engine failure.

Dump Valve:

An uprated dump valve is required with this package due to the well-known weak diaphragms on the original diverter valve. The GFB replaces plastic valve parts with an anodised billet aluminium housing, fitted with a brass piston machined to exact tolerances enabling the additional boost.

Intercooler:

Airtec front mount intercooler kit, Huge surface area, but still allows plenty of airflow to the top section of the radiator, which is essential for hotter climate countries, Width: 760mm Height: 175mm Depth: 60mm

Motorsport Oil Feed Pipe:

This oil feed pipe is a PTFE-lined stainless steel braided flexible hose with a crimped stainless steel banjo. It is also wrapped in a silicone fire sleeve with is rated up to 1100 degrees Celsius and is an upgrade to the standard which is prone to leaking once removed.

Expected dispatch time within 5 working days. This time can vary depending on what extras you decide to purchase. We also offer a full fitting service, please contact us for more information.

Picture for illustration purposes only - actual parts may differ from those shown.